JUTTA WICKELROCK PUPPE

Transcript for the video: Jutta Doll Skirt Video

Hi everyone, in this video I’m going to show you how to make the Jutta skirt for your doll. This is a very quick project—around 20 minutes, or 30 to 40 minutes if you take your time.

It’s a simple wrap-style skirt with a small amount of elastic at the back for shaping. It fits quite snugly, which gives a nice clean look.

You can close it with a button and buttonhole, Cam snaps, or Velcro depending on your preference.

Pattern Overview

This skirt uses only two main pattern pieces plus a facing. The facing includes a marking for the center front, which helps create the wrap-over effect.

The back includes a tunnel for elastic. The elastic is approximately 2 cm wide (0.8 in) and about 13 cm long (just over 5 in), but always follow your pattern markings.

Preparing the Facing

First, overlock both side edges and the lower edge of the facing. Leave the top edge raw for now.

Then attach the facing to the skirt by aligning the center back points. The facing is slightly shorter because it folds over once attached.

Sew both sides with a 1 cm seam allowance and lock your stitches at the start and end.

Next, fold the facing over and sew along the waist edge. This creates the wrap structure of the skirt.

Trim back the seam allowance to about 3 mm so it sits neatly when turned.

Attaching the Facing

Sew the facing to the hem edge on both sides using a 1 cm seam allowance.

Then under-stitch the facing. This means sewing the seam allowance onto the facing close to the edge. This step helps the facing roll neatly to the inside and gives a much cleaner finish.

After this, press the entire piece and turn up the hem by about 1 cm.

Elastic Tunnel

Sew along the marked tunnel line to create the casing for the elastic. Follow the dotted line on your pattern.

Insert the elastic using a safety pin and thread it through the tunnel.

Make sure a small section of elastic is visible on both ends so you can secure it later.

Securing the Elastic

Adjust the elastic evenly so it gathers the back of the skirt nicely.

Pin both ends slightly inside the marked lines (not directly on them), then stitch vertically to secure each end in place.

This keeps the elastic stable and prevents it from shifting.

Closure (Velcro or Button)

Attach Velcro or your chosen fastening.

One side goes on the underside of the wrap so it stays hidden. The other side is placed on the outer wrap section.

If using a button, position it so it does not extend beyond the edge of the skirt. Leave at least 1.2 cm from the top edge for the buttonhole placement.

Always test the buttonhole size first on scrap fabric.

Buttonhole Tips

Place the button in the machine’s buttonhole foot and test the size. The buttonhole should be only slightly longer than the button.

If your machine struggles with thick seam intersections, start your buttonhole from the easier side and adjust placement if needed.

Cut the buttonhole carefully using a pin at the end to prevent accidental cutting through the fabric.

Button Attachment

Sew the button on securely with several passes of thread. Leave a small gap between the button and fabric so it fastens easily without pulling.

Wrap the thread around the base to form a shank, then secure and cut off.

Finishing

Give the skirt a final press. The wrap should sit neatly, with the elastic shaping the back and the front lying flat.

And that’s it—you’re done.

The Jutta skirt is complete, and it pairs beautifully with the matching coat if you’re making the full set.